User's Manual

C HAPTER 3 | System Configuration
Setup Wizard
– 35 –
◆ Protocol — The protocol used will be specified by your service
provider. Choose from the following options:
■
PPPoE — Point-to-Point Protocol over Ethernet (PPPoE).
■
PPPoA — Point-to-Point Protocol over Asynchronous Transfer Mode
(PPPoA).
■
1483 MER : DHCP — 1483 MER is an RFC standard MAC
Encapsulated Routing protocol.
■
1483 MER : Static IP — 1483 MER is an RFC standard MAC
Encapsulated Routing protocol.
■
1483 Bridged — The Bridged RFC 1483 Encapsulated Traffic over
ATM feature allows you to send bridged RFC 1483 encapsulated
packets over ATM switched virtual circuits (SVCs).
■
1483 Routed — Allows you to send routed RFC 1483 encapsulated
packets over ATM switched virtual circuits (SVCs).
■
IPoA — Dynamic IP over ATM (IPoA).
◆ Connection Type — Your connection type will also be specified by your
service provider. Choose from the following options:
■
VC-Mux — Virtual circuit multiplexing (VC-Mux).
■
LLC — Logical Link Control (LLC).
◆ VPI — The ATM Virtual Path Identifier. (Range: 0-255)
◆ VCI — The ATM Virtual Channel Identifier. (Range: 32-65535)
◆ Username — Enter the username provided by your service provider.
◆ Password — Enter the password provided by your service provider.
◆ Confirm Password — Re-enter your password.