Network Card User Manual

C ONFIGURING THE S WITCH
2-18
To start the new firmware, reboot the system.
Command Line Interface
Enter the IP address of the TFTP server. Select the config or opcode file
type. Enter the source and destination file names. Set the new file to boot
the system.
To start the new firmware, enter the “reload” command or reboot the
system.
Saving or Restoring Configuration Settings
You can upload/download configuration settings to/from a TFTP server.
The configuration file can be later downloaded to restore the switch’s
settings.
Command Usage
•
The destination configuration file name should not contain slashes (\
or /),
the leading letter of the file name should not be a period (.), and
Console#copy tftp file 3-19
TFTP server ip address: 10.1.0.15
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: vdsl(v1.8.1.1ZZ.bix
Destination file name: v1811zz.bix
/
Console#config
Console(config)#boot system opcode: v1811zz.bix 3-25
Console(config)#exit
Console#reload 3-16