Network Card User Manual

C OMMAND L INE I NTERFACE
3-164
rate-limit (interface)
Use this command in Interface Configuration mode to configure the rate
limit on data received on a specific port. Use the no form of this command
to return to the default settings. Note that the maximum data rate for
VDSL ports depends on the physical link and the selected efm profile
(see page 3-147.)
Syntax
rate-limit input rate
rate – The rate unit is Mbps
Default Setting
Fast Ethernet interface – 100 Mbps
Gigabit Ethernet interface – 1000 Mbps
Command Mode
Interface Configuration
Command Usage
•The rate range is:
- Fast Ethernet interface – 1 to 100 Mbps.
- Gigabit Ethernet interface – 1 to 1000 Mbps.
• Resolution – the unit increment of rate change:
- Fast Ethernet interface – 1 Mbps.
- Gigabit Ethernet interface – 8 Mbps
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 10
Console(config-if)#