Network Card User Manual

C OMMAND L INE I NTERFACE
3-148
Command Usage
Assigns the same profile to each VDSL switch port. Details of these
profiles are given in the table below:
Notes: 1. The actual data rates may be somewhat less than those shown
in the table above depending on the protocols/applications
used.
2. If the “LL” type profile is selected, the error rate due to noise
in transmission is increased but the signal latency is reduced.
3. The “Public” profiles conform to specific standards such as
ANSI or ETSI. The “Private” profiles do not conform to these
standards.
4. Profiles “user-1” and “user-2” are user-configured profiles.
The values shown for the downstream and upstream rates are
Profile Name Profile Type Downstream Rate
(Mbps)
Upstream Rate
(Mbps)
default Private 4.17 1.56
efm-5 Private 6.25 6.25
efm-10 Private 12.50 12.50
efm-15 Private 16.67 18.75
public-ansi Public 16.67 4.67
public-etsi Public 12.50 4.67
efm-5 LL Private 6.25 6.25
efm-10 LL Private 12.50 12.50
efm-15 LL Private 16.67 18.75
public-ansiLL Public 16.67 4.67
public-etsiLL Public 12.50 4.67
efm-15-3LL Private 16.67 3.13
efm-15-2LL Private 16.67 2.08
efm-15-1LL Private 16.67 1.56
efm-10-2 LL Private 12.50 2.08
user-1 Private 4.00 1.00
user-2 Private 4.00 1.00