Network Card User Manual

C OMMAND L INE I NTERFACE
3-138
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target
port.
Note: The access mode shown in the table is indicated by these
abbreviations: NE (Normal Exec), PE (Privileged Exec),
GC (Global Configuration), IC (Interface Configuration),
LC (Line Configuration), VC (VLAN Database Configuration.)
port monitor
Use this command to configure a mirror session. Use the no form to clear
a mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
- unit - Switch (unit 1.)
- port - Port number.
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Command Function Mode Page
port monitor Configures a mirror session IC 3-138
show port monitor Shows the configuration for a
mirror port
PE 3-140