Network Card User Manual

P RIORITY C OMMANDS
3-131
map ip port (Interface Configuration)
Use this command to set IP port priority (i.e., TCP/UDP port priority.)
Use the no form to remove a specific setting.
Syntax
map ip port port-number cos cos-value
no map ip port port-number
• port-number - 16-bit TCP/UDP port number. (Range: 0-65535)
• cos-value - Class-of-Service value (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
Example
The following example shows how to map HTTP traffic to CoS value 0:
map ip precedence (Global Configuration)
Use this command to enable IP precedence mapping (i.e., IP Type of
Service.) Use the no form to disable IP precedence mapping.
Syntax
map ip precedence
no map ip precedence
Default Setting
Disabled
Command Mode
Global Configuration
Console(config)#interface ethernet 1/5
Console(config-if)#map ip port 80 cos 0
Console(config-if)#