Network Card User Manual

IGMP S NOOPING C OMMANDS
3-119
Command Usage
If enabled, the switch will serve as querier if elected. The querier is
responsible for asking hosts if they want to receive multicast traffic.
Example
ip igmp snooping query-count
Use this command to configure the query count. Use the no form to
restore the default.
Syntax
ip igmp snooping query-count count
no ip igmp snooping query-count
count - The maximum number of queries issued for which there has
been no response before the switch takes action to solicit reports.
(Range: 2-10)
Default Setting
2 times
Command Mode
Global Configuration
Example
The following shows how to configure the query count to 10:
ip igmp snooping query-interval
Use this command to configure the snooping query interval. Use the no
form to restore the default.
Syntax
ip igmp snooping query-interval seconds
no ip igmp snooping query-interval
Console(config)#ip igmp snooping querier
Console(config)#
Console(config)#ip igmp snooping query-count 10
Console(config)#