Network Card User Manual

IGMP S NOOPING C OMMANDS
3-115
Note: The access mode shown in the table is indicated by these
abbreviations: NE (Normal Exec), PE (Privileged Exec),
GC (Global Configuration), IC (Interface Configuration),
LC (Line Configuration), VC (VLAN Database Configuration.)
ip igmp snooping
Use this command to enable IGMP snooping on this switch. Use the no
form to disable it.
Syntax
ip igmp snooping
no ip igmp snooping
Default Setting
Enabled
Command Mode
Global Configuration
Example
The following example enables IGMP snooping.
ip igmp snooping vlan static
Use this command to add a port to a multicast group. Use the no form to
remove the port.
Syntax
ip igmp snooping vlan vlan-id static ip-address interface
Mulitcast Router Commands
ip igmp snooping vlan
mrouter
Adds a multicast router port GC 3-122
show ip igmp snooping
mrouter
Shows multicast router ports PE 3-123
Console(config)#ip igmp snooping
Console(config)#
Command Function Mode Page