Network Card User Manual

C OMMAND L INE I NTERFACE
3-102
Command Usage
• If the switchport mode is set to trunk, the PVID will be inserted into
all untagged frames sent from a tagged port.
• If ingress filtering in disabled, all untagged frames received on this
port will be assigned to the VLAN indicated by the PVID.
Example
The following example shows how to set the PVID for port 1 to
VLAN 3:
switchport allowed vlan
Use this command to configure VLAN groups on the selected interface.
Use the no form to restore the default.
Syntax
switchport allowed vlan {add vlan-list [tagged | untagged]
|remove vlan-list} no switchport allowed vlan
• add vlan-list - List of VLAN identifiers to add.
• remove vlan-list - List of VLAN identifiers to remove. Separate
nonconsecutive VLAN identifiers with a comma and no spaces;
use a hyphen to designate a range of IDs. Do not enter leading
zeros. (Range: 1-4094)
Default Setting
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
You must enter the switchport mode command before the switchport
allowed vlan command can take effect.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#