Network Card User Manual

C OMMAND L INE I NTERFACE
3-96
Note: The access mode shown in the table is indicated by these
abbreviations: NE (Normal Exec), PE (Privileged Exec),
GC (Global Configuration), IC (Interface Configuration),
LC (Line Configuration), VC (VLAN Database Configuration.)
vlan database
Use this command to enter VLAN database mode. All commands in this
mode will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the
VLAN settings by entering the show vlan command.
•Use the interface vlan command mode to define the port
membership mode and add or remove ports from a VLAN. The
results of these commands are written to the running-configuration
file, and you can display this file by entering the show
running-config command.
Display VLAN Information
show vlan Shows VLAN information NE,
PE
3-104
show interfaces
status vlan
Displays status for the specified VLAN
interface
NE,
PE
3-76
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE,
PE
3-78
Command Function Mode Page