Network Card User Manual

A DDRESS T ABLE C OMMANDS
3-79
Address Table Commands
These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or setting
the aging time.
Note: The access mode shown in the table is indicated by these
abbreviations: NE (Normal Exec), PE (Privileged Exec),
GC (Global Configuration), IC (Interface Configuration),
LC (Line Configuration), VC (VLAN Database Configuration.)
bridge address
Use this command to map a static address to a port in a VLAN. Use the no
form to remove an address.
Syntax
bridge bridge-group address mac-address vlan vlan-id forward interface
[action]
no bridge bridge-group address mac-address vlan vlan-id
Command Function Mode Page
bridge address Maps a static address to a port in a VLAN GC 3-79
show bridge Displays classes of entries in the
bridge-forwarding database
PE 3-81
clear bridge Removes any learned entries from the
forwarding database and clears the transmit
and receive counts for any statically or system
configured entries
PE 3-82
bridge-group
aging-time
Sets the aging time of the address table GC 3-82
show bridge
aging-time
Shows the aging time for the address table PE 3-83