Network Card User Manual

C OMMAND L INE I NTERFACE
3-72
capabilities
Use this command to advertise the port capabilities of a given interface
during auto-negotiation. Use the no form with parameters to remove an
advertised capability, or the no form without parameters to restore the
default values
Syntax
capabilities {1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric}
no port-capabilities [1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric]
• 1000full - Supports 1000 Mbps full-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 10half - Supports 10 Mbps half-duplex operation
• flowcontrol - Supports flow control
• symmetric - Transmits and receives pause frames for flow
control (Gigabit ports only)
Default Setting
The default values for Fast Ethernet include 10half, 10full, 100half,
100full and flow control. The default values for Gigabit Ethernet
include all settings.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following example configures Ethernet port 5 capabilities to
100half, 100full and flow control.
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#