Network Card User Manual

C OMMAND L INE I NTERFACE
3-68
Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Note: The access mode shown in the table is indicated by these
abbreviations: NE (Normal Exec), PE (Privileged Exec),
GC (Global Configuration), IC (Interface Configuration),
LC (Line Configuration), VC (VLAN Database Configuration.)
Command Function Mode Page
interface Configures an interface type and enters
interface configuration mode
GC 3-69
description Adds a description to an interface
configuration
IC 3-69
speed-duplex Configures the speed and duplex operation
of a given interface when auto-negotiation is
disabled
IC 3-70
negotiation Enables auto-negotiation of a given interface IC 3-71
capabilities Advertises the capabilities of a given
interface for use in auto-negotiation
IC 3-72
flowcontrol Enables flow control on a given interface IC 3-73
clear counters Clears the statistics on a given interface PE 3-74
shutdown Disables an interface IC 3-74
switchport
broadcast
Configures broadcast storm control IC 3-75
show interfaces
status
Displays status for the specified interface NE, PE 3-76
show interfaces
counters
Displays statistics for the specified interface NE, PE 3-77
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE, PE 3-78