Network Card User Manual

C OMMAND L INE I NTERFACE
3-58
Line Commands
Access the on-board configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal.)
Note: The access mode shown in the table is indicated by these
abbreviations: NE (Normal Exec), PE (Privileged Exec),
GC (Global Configuration), IC (Interface Configuration),
LC (Line Configuration), VC (VLAN Database Configuration.)
Command Function Mode Page
line Identifies a specific line for configuration
and starts the line configuration mode
GC 3-59
login Enables password checking at login LC 3-59
password Specifies a password on a line LC 3-60
exec-timeout Sets the interval with no user input after
which the current session will be terminated
LC 3-61
password-thresh Sets the password intrusion threshold,
which limits the number of failed logon
attempts
LC 3-62
silent-time Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the password-thresh
command
LC 3-63
databits Sets the number of data bits per character
that are interpreted and generated by
hardware
LC 3-64
parity Defines the generation of a parity bit LC 3-65
speed Sets the terminal baud rate LC 3-65
stopbits Sets the number of the stop bits transmitted
per byte
LC 3-66
show line Displays a terminal line's parameters NE,
PE
3-67