Network Card User Manual

SNMP C OMMANDS
3-47
Example
Related Commands
snmp-server contact
snmp-server host
Use this command to specify the recipient of a Simple Network
Management Protocol notification operation. Use the no form to remove
the specified host.
Syntax
snmp-server host host-addr community-string
no snmp-server host host-addr
• host-addr - Name or Internet address of the host (the targeted
recipient)
(Maximum host addresses: 5 trap destination ip address entries)
• community-string - Password-like community string sent with the
notification operation. Though you can set this string using the
snmp-server host command by itself, we recommend you define
this string using the snmp-server community command prior
to using the snmp-server host command. (maximum length: 32
characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
If you do not enter an snmp-server host command, no notifications
are sent. In order to configure the switch to send SNMP
notifications, you must enter at least one snmp-server host command.
To enable multiple hosts, you must issue a separate snmp-server host
command for each host.
Console(config)#snmp-server location R&D 3F
Console(config)#