Network Card User Manual

C OMMAND L INE I NTERFACE
3-8
To enter Privileged Exec mode, enter the following commands and
passwords:
Configuration Commands
Configuration commands are privileged level commands used to modify
switch settings. These commands modify the running configuration only
and are not saved when the switch is rebooted. To store the running
configuration in nonvolatile storage, use the copy running-config
startup-config command.
The configuration commands are organized into three different modes:
• Global Configuration – These commands modify the system level
configuration, and include commands such as hostname and
snmp-server community.
• Interface Configuration – These commands modify the port
configuration such as speed-duplex and negotiation.
• Line Configuration – These commands modify the console port
configuration, and include command such as parity and databits.
To enter the Global Configuration mode, enter the command configure
in Privileged Exec mode. The system prompt will change to
Username: admin
Password: [system login password]
CLI session with the host is opened.
To end the CLI session, enter [Exit].
Console#
Username: guest
Password: [system login password]
CLI session with the host is opened.
To end the CLI session, enter [Exit].
Console#enable
Password: [privileged level password]
Console#