- SMC Cable/DSL Broadband Router User Guide

Getting to Know the Barricade™
6
LED Indicators
The Barricade™ includes LED indicators on the front panel that
simplify installation and network troubleshooting.
LED ON OFF FLASHING
PWR Receiving power Not receiving power N/A
WAN Good WAN
connection detected
No WAN connection
detected
Transmitting or
receiving traffic
LINK/ACT Good LAN
connection detected
No LAN connection
detected
Transmitting or
receiving traffic
10/100 Mbps LAN port operating
at 100 Mbps
LAN port operating
at 10 Mbps
N/A
Resetting the Barricade™
The [Reset] button is located on the rear panel of the Barricade™
Broadband Router. Use a paper clip or a pencil tip to push the
Reset button.
Reset
If the Router is having problems connecting to the Internet,
simply unplug the router for 3 seconds then plug back in.
Restore Factory Defaults
If resetting the router does not resolve your issue, then you
can follow these steps:
1. Leave power plugged into the router.
2. Locate the [Reset] button on the back panel, press and
hold until WAN LED flashes off.
3. Release [Reset] button.