Network Device User Guide SMC7003-USB

H ARDWARE I NSTALLATION
2-5
Connect the System
Phone Line Configuration
The EZ Connect ADSL USB Modem supports dual-mode operation
for both full-rate G.dmt and economical G.lite. Your service
provider will therefore attach the outside ADSL line to a data/
phone splitter. You can then connect your phones and computer
directly to the splitter as shown below:
Depending on the wiring configuration used in your house,
separate wall jacks may be used for telephone and voice signals.
Otherwise, you will need to connect your phones and PC directly
to the splitter.
1. Connect the modem’s ADSL port to the data port on the splitter
(or to an RJ-11 telephone wall jack connected to this port)
using standard telephone cable.
2. Insert the USB cable’s Type-B plug (square end) into the
modem’s USB port.
3. Install the driver
Voice
Data
Splitter
Residential
Connection
Point (NID)
Plain Old
Telephone
System (POTS)
SMC7003-USB