Switch User Manual

U SING THE S YSTEM C ONFIGURATION P ROGRAM
2-12
IP Configuration
Use the IP Configuration screen to set the bootup option, or
configure the switch’s IP parameters. The screen shown below is
described in the following table.
MAX Number of Allowed
Telnet Sessions
The maximum number of Telnet sessions
allowed to simultaneously access the agent
module.
MAC Address Physical address of the agent module.
Network Configuration : IP Configuration
========================================
Interface Type : Ethernet
IP Address : 10.1.113.29
Subnet Mask : 255.255.0.0
Gateway IP :
IP State : USER-CONFIG
<APPLY> <OK> <CANCEL>
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter Description
Interface Type Indicates IP over Ethernet.
IP Address IP address of the stack you are managing. The system
supports SNMP over UDP/IP transport protocol. In this
environment, all systems on the Internet, such as
network interconnection devices and any PC accessing
the agent module (or running EliteView) must have an
IP address.
Valid IP addresses consist of four numbers, of 0 to 255,
and separated by periods. Anything outside of this
format will not be accepted by the configuration
program.
Subnet Mask Subnet mask of the switch you have selected. This mask
identifies the host address bits used for routing to
specific subnets.
Parameter Description