24-Port Layer 3 Switch Management Guide

SER

UTHENTICATION

3-39

CLI – This example sets the authentication mode to enable dot1x on

port 2.

Displaying 802.1x Statistics

This switch can display statistics for dot1x protocol exchanges for any

port.

Statistical Values

Console(config)#interface ethernet 1/2 4-119

Console(config-if)#dot1x port-control auto 4-68

Console(config-if)#

Parameter Description

Rx EXPOL Start The number of EAPOL Start frames that have been

received by this Authenticator.

Rx EAPOL Logoff The number of EAPOL Logoff frames that have been

received by this Authenticator.

Rx EAPOL Invalid The number of EAPOL frames that have been received

by this Authenticator in which the frame type is not

recognized.

Rx EAPOL Total The number of valid EAPOL frames of any type that

have been received by this Authenticator.

Rx EAP Resp/Id The number of EAP Resp/Id frames that have been

received by this Authenticator.

Rx EAP Resp/Oth The number of valid EAP Response frames (other than

Resp/Id frames) that have been received by this

Authenticator.

Rx EAP LenError The number of EAPOL frames that have been received

by this Authenticator in which the Packet Body Length

field is invalid.

Rx Last EAPOLVer The protocol version number carried in the most

recently received EAPOL frame.

Rx Last EAPOLSrc The source MAC address carried in the most recently

received EAPOL frame.

Tx EAPOL Total The number of EAPOL frames of any type that have

been transmitted by this Authenticator.