24-Port Layer 3 Switch Management Guide

C ONFIGURING THE S WITCH
3-20
CLI – Specify the management interface, IP address and default gateway.
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the
switch to be dynamically configured by these services.
Web – Click IP, General, Routing Interface. Specify the VLAN to which
the management station is attached, set the IP Address Mode to DHCP or
BOOTP. Click Apply to save your changes. Then click Restart DHCP to
immediately request a new address. Note that the switch will also broadcast
a request for IP configuration settings on each power reset.
Note: If you lose your management connection, use a console connection
and enter “show ip interface” to determine the new switch address.
Console#config
Console(config)#interface vlan 1 4-119
Console(config-if)#ip address 10.1.0.254 255.255.255.0 4-216
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254 4-218
Console(config)#