24-Port Layer 3 Switch Management Guide

M ULTICAST R OUTING C OMMANDS
4-301
show ip dvmrp interface
Use this command to display the DVMRP configuration for interfaces
which have enabled DVMRP.
Command Mode
Normal Exec, Privileged Exec
Example
PIM-DM Multicast Routing Commands
Console#show ip dvmrp interface
Vlan 1 is up
DVMRP is enabled
Metric is 1
Console#
Command Function Mode Page
router pim Enables PIM globally for the router GC 4-302
ip pim dense-mode Enables PIM on the specified interface IC 4-303
ip pim hello-interval Sets the interval between sending PIM hello
messages
IC 4-304
ip pim hello-holdtime Sets the time to wait for hello messages
from a neighboring PIM router before
declaring it dead
IC 4-305
ip pim
trigger-hello-interval
Sets the maximum time before sending a
triggered PIM Hello message
IC 4-305
ip pim
join-prune-holdtime
Configures the hold time for the prune state IC 4-306
ip pim
graft-retry-interval
Configures the time to wait for a Graft
acknowledgement before resending a Graft
message
IC 4-307
ip pim
max-graft-retries
Configures the maximum number of times
to resend a Graft message if it has not been
acknowledged
IC 4-308
show router pim Displays the global PIM configuration
settings
NE,
PE
4-308