24-Port Layer 3 Switch Management Guide
C
ONFIGURING
THE
S
WITCH
3-10
Routing Protocol 3-152
RIP 3-175
General Settings Enables or disables RIP, sets the global RIP
version and timer values
3-176
Network Addresses Configures the network interfaces that will use
RIP
3-178
Interface Settings Configure RIP parameters for each interface,
including send and receive versions, message
loopback prevention, and authentication
3-179
Statistics Displays general information on update time,
route changes and number of queries, as well as
a list of statistics for known interfaces and
neighbors
3-183
OSPF 3-186
General
Configuration
Enables or disables OSPF; also configures the
Router ID and various other global settings
3-188
Area Configuration Specifies rules for importing routes into each
area
3-192
Area Range
Configuration
Configures route summaries to advertise at an
area boundary
3-196
Interface
Configuration
Shows area ID and designated router; also
configures OSPF protocol settings and
authentication for each interface
3-198
Virtual Link
Configuration
Configures virtual link through transit area to
backbone
3-204
Network Area
Address
Configuration
Defines OSPF areas and associated interfaces 3-206
Summary Address
Configuration
Aggregates routes learned from other protocols
for advertising into other autonomous systems
3-208
Redistribute
Configuration
Redistributes routes from one routing domain to
another
3-210
Menu Description Page