24-Port Layer 3 Switch Management Guide

M ULTICAST R OUTING C OMMANDS
4-293
nbr-timeout
Use this command to set the interval to wait for messages from a DVMRP
neighbor before declaring it dead. Use the no form to restore the default
value.
Syntax
nbr-timeout seconds
seconds - Interval before declaring a neighbor dead. (Range: 1-65535)
Default Setting
35 seconds
Command Mode
Router Configuration
Command Usage
This command is used for timing out routes, and for setting the
children and leaf flags.
Example
report-interval
Use this command to specify how often to propagate the complete set of
routing tables to other neighbor DVMRP routers. Use the no form to
restore the default value.
Syntax
report-interval seconds
seconds - Interval between sending the complete set of routing
tables. (Range: 1-65535)
Default Setting
60 seconds
Console(config-router)#nbr-timeout 40
Console(config-router)#