24-Port Layer 3 Switch Management Guide

C OMMAND L INE I NTERFACE
4-292
Related Commands
ip dvmrp (4-296)
show router dvmrp (4-298)
probe-interval
Use this command to set the interval for sending neighbor probe messages
to the multicast group address for all DVMRP routers. Use the no form to
restore the default value.
Syntax
probe-interval seconds
seconds - Interval between sending neighbor probe messages.
(Range: 1-65535)
Default Setting
10 seconds
Command Mode
Router Configuration
Command Usage
Probe messages are sent to neighboring DVMRP routers from which
this device has received probes, and is used to verify whether or not
these neighbors are still active members of the multicast tree.
Example
Console(config-router)#probe-interval 30
Console(config-router)#