24-Port Layer 3 Switch Management Guide

M ULTICAST R OUTING C OMMANDS
4-291
router dvmrp
Use this command to enable Distance-Vector Multicast Routing (DVMRP)
globally for the router and to enter router configuration mode. Use the no
form to disable DVMRP multicast routing.
Syntax
router dvmrp
no router dvmrp
Command Mode
Global Configuration
Command Usage
This command enables DVMRP globally for the router and enters
router configuration mode. Make any changes necessary to the global
DVMRP parameters. Then specify the interfaces that will support
DVMRP multicast routing using the ip dvmrp command, and set the
metric for each interface.
Example
show ip dvmrp route Displays DVMRP routing information NE,
PE
4-299
show ip dvmrp
neighbor
Displays DVMRP neighbor information NE,
PE
4-300
show ip dvmrp
interface
Displays DVMRP configuration settings
for the interfaces
NE,
PE
4-301
Console(config)#router dvmrp
Console(config-router)#end
Console#show router dvmrp
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway : 0.0.0.0
Metric of Default Gateway : 0
Console#
Command Function Mode Page