24-Port Layer 3 Switch Management Guide

C OMMAND L INE I NTERFACE
4-290
This example lists all entries in the multicast table in summary form:
DVMRP Multicast Routing Commands
Console#show ip mroute summary
IP Multicast Forwarding is enabled.
IP Multicast Routing Table (Summary)
Flags: P - Prune UP
Group Source Source Mask Interface Owner Flags
--------------- --------------- --------------- ---------- ------- ------
224.1.1.1 10.1.0.0 255.255.0.0 vlan1 DVMRP P
224.2.2.2 10.1.0.0 255.255.0.0 vlan1 DVMRP --
Console#
Command Function Mode Page
router dvmrp Enables DVMRP and enters router
configuration mode
GC 4-291
probe-interval Sets the interval for sending neighbor probe
messages
RC 4-292
nbr-timeout Sets the delay before declaring an attached
neighbor router down
RC 4-293
report-interval Sets the interval for propagating the
complete set of routing tables to other
neighbor routers
RC 4-293
flash-update-interval Sets the interval for sending updates about
changes to network topology
RC 4-294
prune-lifetime Defines how long a prune state remains in
effect for a source-routed multicast tree
RC 4-294
default-gateway Configures the default gateway for IP
multicast routing
RC 4-295
ip dvmrp Enables DVMRP on the specified interface IC 4-296
ip dvmrp metric Sets the metric used when establishing
reverse paths to some networks on directly
attached interfaces
IC 4-297
clear ip dvmrp route Clears all dynamic routes in the multicast
routing table
PE 4-298
show router dvmrp Displays global DVMRP configuration
settings
NE,
PE
4-298