24-Port Layer 3 Switch Management Guide

C OMMAND L INE I NTERFACE
4-234
Default Setting
No networks are specified.
Command Usage
• RIP only sends updates to interfaces specified by this command.
• Subnet addresses are interpreted as class A, B or C, based on the first
field in the specified address. In other words, if a subnet address
nnn.xxx.xxx.xxx is entered, the first field (nnn) determines the class:
0 - 127 is class A, and only the first field in the network address is used.
128 - 191 is class B, and the first two fields in the network address are
used.
192 - 223 is class C, and the first three fields in the network address are
used.
Example
This example includes network interface 10.1.0.0 in the RIP routing
process.
Related Commands
router rip (4-231)
neighbor
Use this command to define a neighboring router with which this router
will exchange routing information. Use the no form to remove an entry.
Syntax
neighbor ip-address
no neighbor ip-address
ip-address - IP address to map to a specified hardware address.
Command Mode
Router Configuration
Default Setting
No neighbors are defined.
Console(config-router)#network 10.1.0.0
Console(config-router)#