24-Port Layer 3 Switch Management Guide

C OMMAND L INE I NTERFACE
4-232
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
• RIP is used to specify how routers exchange routing table information.
• This command is also used to enter router configuration mode.
Example
Related Commands
network (4-233)
timers basic
Use this command to configure the RIP update timer, timeout timer, and
garbage- collection timer. Use the no form to restore the defaults.
Syntax
timers basic update-seconds
no timers basic
update-seconds – Sets the update timer to the specified value, sets the
timeout time value to 6 times the update time, and sets the
garbage- collection timer to 4 times the update time.
(Range for update timer: 15-60 seconds)
Command Mode
Router Configuration
Default Setting
Update: 30 seconds
Timeout: 180 seconds
Garbage collection: 120 seconds
Console(config)#router rip
Console(config-router)#