24-Port Layer 3 Switch Management Guide

IP R OUTING C OMMANDS
4-231
Routing Information Protocol (RIP)
router rip
Use this command to enable Routing Information Protocol (RIP) routing
for all IP interfaces on the router. Use the no form to disable it.
Syntax
router rip
no router rip
Command Function Mode Page
router rip Enables the RIP routing protocol GC 4-231
timers basic Sets basic timers, including update, timeout,
garbage collection
RC 4-232
network Specifies the network interfaces that are to use
RIP routing
RC 4-233
neighbor Defines a neighboring router with which to
exchange information
RC 4-234
version Specifies the RIP version to use on all network
interfaces (if not already specified with a receive
version or send version command)
RC 4-235
ip rip receive
version
Sets the RIP receive version to use on a
network interface
IC 4-236
ip rip send version Sets the RIP send version to use on a network
interface
IC 4-237
ip split-horizon Enables split-horizon or poison-reverse loop
prevention
IC 4-239
ip rip
authentication key
Enables authentication for RIP2 packets and
specifies keys
IC 4-240
ip rip
authentication
mode
Specifies the type of authentication used for
RIP2 packets
IC 4-241
show rip globals Displays global configuration settings and
statistics for RIP
PE 4-242
show ip rip Displays RIP configuration information for
each network interface
PE 4-242