24-Port Layer 3 Switch Management Guide

IP I

NTERFACE

OMMANDS

4-215

IP Interface Commands

There are no IP addresses assigned to this router by default. You must

manually configure a new address to manage the router over your network

or to connect the router to existing IP subnets. You may also need to a

establish a default gateway between this device and management stations

or other devices that exist on another network segment (if routing is not

enabled).

This section includes commands for configuring IP interfaces, the Address

Resolution Protocol (ARP) and Proxy ARP. These commands are used to

connect subnetworks to the enterprise network.

Basic IP Configuration

Command Group Function Page

Basic IP

Configuration

Configures the IP address for interfaces and the

gateway router

4-215

Address Resolution

Protocol (ARP)

Configures static, dynamic and proxy ARP service 4-221

Command Function Mode Page

ip address Sets the IP address for the current interface IC 4-216

ip default-gateway Defines the default gateway through which this

router can reach other subnetworks

GC 4-218

show ip interface Displays the IP settings for this device PE 4-219

show ip redirects Displays the default gateway configured for

this device

PE 4-219

ping Sends ICMP echo request packets to another

node on the network

NE,

4-220