24-Port Layer 3 Switch Management Guide

M ULTICAST F ILTERING C OMMANDS
4-205
Command Mode
Global Configuration
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Related Commands
ip igmp snooping version (4-198)
IGMP Commands (Layer 3)
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Command Function Mode Page
ip igmp Enables IGMP for the specified interface IC 4-206
ip igmp robustval Configures the expected packet loss IC 4-207
ip igmp
query-interval
Configures frequency for sending host
query messages
IC 4-207
ip igmp
max-resp-interval
Configures the maximum host response
time
IC 4-208
ip igmp
last-memb-query-
interval
Configures frequency for sending
group-specific host query messages
IC 4-209
ip igmp version Configures IGMP version used on this
interface
IC 4-210
show ip igmp
interface
Displays the IGMP configuration for
specified interfaces
NE,
PE
4-211
clear ip igmp group Deletes entries from the IGMP cache PE 4-212
show ip igmp groups Displays detailed information for IGMP
groups
NE,
PE
4-213