24-Port Layer 3 Switch Management Guide

C
OMMAND
L
INE
I
NTERFACE
4-164
Default Setting
By default only VLAN 1 exists and is active.
Command Mode
VLAN Database Configuration
Command Usage
no vlan vlan-id deletes the VLAN.
no vlan vlan-id name removes the VLAN name.
no vlan vlan-id state returns the VLAN to the default state (i.e., active).
You can configure up to 255 VLANs on the switch.
Example
The following example adds a VLAN, using VLAN ID 105 and name
RD5. The VLAN is activated by default.
Related Commands
show vlan (4-172)
Configuring VLAN Interfaces
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Command Function Mode Page
interface vlan Enters interface configuration mode for a
specified VLAN
IC 4-165
switchport mode Configures VLAN membership mode for
an interface
IC 4-166
switchport
acceptable-frame-
types
Configures frame types to be accepted by an
interface
IC 4-167
switchport
ingress-filtering
Enables ingress filtering on an interface IC 4-168
switchport native
vlan
Configures the PVID (native VLAN) of an
interface
IC 4-169