24-Port Layer 3 Switch Management Guide

A DDRESS T ABLE C OMMANDS
4-141
Address Table Commands
These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or setting
the aging time.
mac-address-table static
Use this command to map a static address to a destination port in a
VLAN. Use the no form to remove an address.
Syntax
mac-address-table static mac-address interface interface
vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
• mac-address - MAC address.
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-4)
• vlan-id - VLAN ID (Range: 1-4094)
Command Function Mode Page
mac-address-table
static
Maps a static address to a port in a VLAN GC 4-141
clear
mac-address-table
dynamic
Removes any learned entries from the
forwarding database
PE 4-142
show
mac-address-table
Displays entries in the bridge-forwarding
database
PE 4-143
mac-address-table
aging-time
Sets the aging time of the address table GC 4-144
show
mac-address-table
aging-time
Shows the aging time for the address table PE 4-145