24-Port Layer 3 Switch Management Guide

C OMMAND L INE I NTERFACE
4-114
is used (see page 3-178). This command is valid for manual bindings
only.
•The no host command only clears the address from the DHCP server
database. It does not cancel the IP address currently in use by the host.
Example
Related Commands
client-identifier (4-114)
hardware-address (4-115)
client-identifier
Use this command to specify the client identifier of a DHCP client. Use
the no form to remove the client identifier.
Syntax
client-identifier {text text | hex hex}
no client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
DHCP Pool Configuration
Command Usage
• This command identifies a DHCP client to bind to an address specified
in the host command. If both a client identifier and hardware address
are configured for a host address, the client identifier takes precedence
over the hardware address in the search procedure.
Console(config-dhcp)#host 10.1.0.21 255.255.255.0
Console(config-dhcp)#