24-Port Layer 3 Switch Management Guide

F LASH /F ILE C OMMANDS
4-59
boot system
Use this command to specify the file or image used to start up the system.
Syntax
boot system {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom - Boot ROM.
• config - Configuration file.
• opcode - Run-time operation code.
The colon (:) is required.
• filename - Name of the configuration file or image name.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (4-57)
whichboot (4-58)
Console(config)#boot system config: startup
Console(config)#