24-Port Layer 3 Switch Management Guide

F LASH /F ILE C OMMANDS
4-53
Example
Flash/File Commands
These commands are used to manage the system code or configuration
files.
copy
Use this command to move (upload/download) a code image or
configuration file between the switch’s flash memory and a TFTP server.
When you save the system code or configuration settings to a file on a
TFTP server, that file can later be downloaded to the switch to restore
system operation. The success of the file transfer depends on the
accessibility of the TFTP server and the quality of the network connection.
Console#show version
Unit1
Serial number :1111111111
Service tag :
Hardware version :R0A
Number of ports :26
Main power status :up
Redundant power status :not present
Agent(master)
Unit id :1
Loader version :1.0.0.0
Boot rom version :1.0.0.0
Operation code version :1.0.1.3
Console#
Command Function Mode Page
copy Copies a code image or a switch configuration to
or from flash memory or a TFTP server
PE 4-53
delete Deletes a file or code image PE 4-56
dir Displays a list of files in flash memory PE 4-57
whichboot Displays the files booted PE 4-58
boot system Specifies the file or image used to start up the
system
GC 4-59