24-Port Layer 3 Switch Management Guide
C
OMMAND
L
INE
I
NTERFACE
4-40
show logging
Use this command to display the logging configuration, along with any
system and event messages stored in memory.
Syntax
show logging {flash | ram}
• flash - Event history stored in flash memory (i.e., permanent
memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed
on power reset).
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command shows the following information:
• Syslog logging
– Whether or not system logging has been enabled via
the logging on command.
• History logging in FLASH/RAM
– The message level(s) that are
reported based on the logging history command.
• Any system and event messages stored in memory.