24-Port Layer 3 Switch Management Guide

INE

OMMANDS

4-13

Line Commands

You can access the onboard configuration program by attaching a VT100

compatible device to the server’s serial port. These commands are used to

set communication parameters for the serial port or Telnet (i.e., a virtual

terminal).

Command Function Mode Page

line Identifies a specific line for configuration and

starts the line configuration mode

GC 4-14

password Specifies a password on a line LC 4-16

exec-timeout Sets the interval that the command interpreter

waits until user input is detected

LC 4-17

password-thresh Sets the password intrusion threshold, which

limits the number of failed logon attempts

LC 4-18

silent-time* Sets the amount of time the management console

is inaccessible after the number of unsuccessful

logon attempts exceeds the threshold set by the

password-thresh command

LC 4-19

databits* Sets the number of data bits per character that

are interpreted and generated by hardware

LC 4-20

parity* Defines the generation of a parity bit LC 4-21

speed* Sets the terminal baud rate LC 4-22

stopbits* Sets the number of the stop bits transmitted per

byte

LC 4-23

show line Displays a terminal line's parameters NE,

4-23

* These commands only apply to the serial port.