24-Port Layer 3 Switch Management Guide

C OMMAND G ROUPS
4-11
Command Groups
The system commands can be broken down into the functional groups
shown below
.
Command Group Description Page
Line Sets communication parameters for the serial port
and Telnet, including baud rate and console time-out
4-13
General Basic commands for entering privileged access mode,
restarting the system, or quitting the CLI
4-24
System
Management
Controls system logs, system passwords, user name,
browser management options, and a variety of other
system information
4-31
Flash/File Manages code image or switch configuration files 4-53
Authentication Configures logon access using local or RADIUS
authentication; also configures IEEE 802.1x port
access control
4-60
Access Control List Provides filtering for IP frames (based on address,
protocol, TCP/UDP port number or TCP control
code) or non-IP frames (based on MAC address or
Ethernet type)
4-74
SNMP Activates authentication failure traps; configures
community access strings, and trap managers
4-90
DHCP Configures DHCP client, relay and server functions 4-97
Interface Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
4-118
Mirror Port Mirrors data to another port for analysis without
affecting the data passing through or the performance
of the monitored port
4-133
Rate Limiting Controls the maximum rate for traffic transmitted or
received on a port
4-135
Link Aggregation Statically groups multiple ports into a single logical
trunk; configures Link Aggregation Control Protocol
for port trunks
4-137
Address Table Configures the address table for filtering specified
addresses, displays current entries, clears the table, or
sets the aging time
4-141