24-Port Layer 3 Switch Management Guide

E NTERING C OMMANDS
4-9
To enter the Global Configuration mode, enter the command configure
in Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode
Console#configure
Console(config)#
Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 4-13
Access
Control
List
access-list ip standard
access-list ip extended
access-list mac
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
4-74
DHCP ip dhcp pool Console(config-dhcp) 4-97
Interface interface {ethernet port |
port-channel id| vlan id}
Console(config-if)# 4-118
VLAN vlan database Console(config-vlan) 4-162
Router router {rip | ospf | dvmrp | pim} Console(config-router) 4-231
4-246
4-291
4-302
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#