24-Port Layer 3 Switch Management Guide

M
ULTICAST
R
OUTING
3-227
CLI – This sets the global parameters for DVMRP and displays the
current settings.
Configuring DVMRP Interface Settings
To fully enable DVMRP, you need to enable multicast routing globally for
the router (page 3-219), enable DVMRP globally for the router
(page 3-223), and also enable DVMRP for each interface that will
participate in multicast routing.
Command Attributes
DVMRP Interface Information
Interface – VLAN interface on this router that has enabled DVMRP.
Address – IP address of this VLAN interface.
Metric – The metric for this interface used to calculate distance vectors.
Status – Shows that DVMRP is enabled on this interface.
DVMRP Interface Settings
VLAN – Selects a VLAN interface on this router.
Metric Sets the metric for this interface used to calculate distance
vectors.
Console(config)#router dvmrp 4-291
Console(config-router)#probe-interval 30 4-292
Console(config-router)#nbr-timeout 40 4-293
Console(config-router)#report-interval 90 4-293
Console(config-router)#flash-update-interval 10 4-294
Console(config-router)#prune-lifetime 5000 4-294
Console(config-router)#default-gateway 10.1.0.253 4-295
Console(config-router)#end
Console#show router dvmrp 4-298
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway :
Console#