24-Port Layer 3 Switch Management Guide

C ONFIGURING THE S WITCH
3-178
CLI - This example sets the router to use RIP Version 2, and sets the basic
timer to 15 seconds.
Specifying Network Interfaces for RIP
You must specify network interfaces that will be included in the RIP
routing process.
Command Usage
• RIP only sends updates to interfaces specified by this command.
• Subnet addresses are interpreted as class A, B or C, based on the first field
in the specified address. In other words, if a subnet address
nnn.xxx.xxx.xxx is entered, the first field (nnn) determines the class:
• 0 - 127 is class A, and only the first field in the network address is used.
• 128 - 191 is class B, and the first two fields in the network address are
used.
• 192 - 223 is class C, and the first three fields in the network address are
used.
Command Attributes
• Subnet Address – IP address of a network directly connected to this
router.
Console(config)#router rip 4-231
Console(config-router)#version 2 4-235
Console(config-router)#timers basic 15 4-232
Console(config-router)#end
Console#show rip globals 4-242
RIP Process: Enabled
Update Time in Seconds: 15
Number of Route Change: 0
Number of Queries: 1
Console#