24-Port Layer 3 Switch Management Guide

C ONFIGURING THE S WITCH
3-132
Click Priority, IP Port Priority. Select a port or trunk from the Interface
field. Enter the port number for a network application in the IP Port
Number box and the new CoS value in the Class of Service box, and then
click Add IP Port.
* Mapping specific values for IP Port Priority is implemented as an interface
configuration command, but any changes will apply to the all interfaces on the
switch.
CLI – The following example globally enables IP Port Priority service on
the switch, maps HTTP traffic (on port 1) to CoS value 0, and then
displays the IP Port Priority settings.
* Mapping specific values for IP Port Priority is implemented as an interface
configuration command, but any changes will apply to the all interfaces on the
switch.
Console(config)#map ip port 4-187
Console(config)#interface ethernet 1/1 4-119
Console(config-if)#map ip port 80 cos 0 4-188
Console(config-if)#end
Console#show map ip port ethernet 1/5 4-193
TCP port mapping status: disabled
Port Port no. COS
--------- -------- ---
Eth 1/ 1 80 0
Console#