24-Port Layer 3 Switch Management Guide
C
ONFIGURING
THE
S
WITCH
3-130
Web – Click Priority, IP DSCP Priority. Select a port or trunk from the
Interface field. Select an entry from the DSCP table, enter a value in the
Class of Service Value field, then click Apply.
* Mapping specific values for IP DSCP is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
CLI – The following example globally enables DSCP Priority service on
the switch, maps DSCP value 0 to CoS value 1 (on port 1), and then
displays the DSCP Priority settings.
* Mapping specific values for IP DSCP is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
Console(config)#map ip dscp 4-191
Console(config)#interface ethernet 1/1 4-119
Console(config-if)#map ip dscp 1 cos 0 4-191
Console(config-if)#end
Console#show map ip dscp ethernet 1/5 4-195
DSCP mapping status: disabled
Port DSCP COS
--------- ---- ---
Eth 1/ 1 0 0
Eth 1/ 1 1 0
Eth 1/ 1 2 0
Eth 1/ 1 3 0
.
.
.
Eth 1/ 1 61 0
Eth 1/ 1 62 0
Eth 1/ 1 63 0
Console#