24-Port Layer 3 Switch Management Guide

C ONFIGURING THE S WITCH
3-52
Command Usage
• You can enable or disable authentication messages via the Web interface.
• You can enable or disable authentication messages or link-up-down
messages via the CLI.
Command Attributes
• Trap Manager Capability – This switch supports up to five trap
managers.
• Trap Manager IP Address – Internet address of the host (the targeted
recipient).
• Trap Manager Community String – Community string sent with the
notification operation. (Range: 1-32 characters, case sensitive)
• Enable Authentication Traps – Issues a trap message whenever an
invalid community string is submitted during the SNMP access
authentication process.
Web – Click SNMP, SNMP Configuration. Fill in the IP address and
community string box for each Trap Manager that will receive these
messages, mark Enable Authentication Traps if required, and then click
Add.
CLI – This example adds a trap manager and enables authentication traps.
Console(config)#snmp-server host 10.1.19.23 batman 4-93
Console(config)#snmp-server enable traps authentication 4-94