- smc User Guide Hub/Switch SMC6724L2GSSC, SMC6724L2GLSC

NSTALLING

THE

ODULE

4. Remove the installed module or faceplate: Firmly pull on

the screws until the module is free of the switch. Carefully

slide the module straight out of the slot.

Keep the original faceplate for future use. If you should

remove the module, replace the faceplate to prevent dust and

debris from entering the unit and to maintain proper air flow.

5. Insert the new module into the switch: Holding the new

module with the text on the front panel upright, carefully slide

the module into the lower slot on the rear panel, and press

gently until it snaps into place. Be sure the new module’s front

panel is flush with the switch panel.

Slot 2Slot 1

1000BASE-SX Module