Hub/Switch Installation Guide SMC6724L2

A BOUT THE T IGER S WITCH 10/100
1-4
Status LEDs
The LEDs, which are located on the front panel for easy viewing,
are shown below and described in the following table.
Figure 1-4. Port and System LEDs
Port and System Status LEDs
LED Condition Status
Power On Switch is receiving power.
RJ-45 Ports
Link &
Activity
On Port has established a valid network
connection.
Yellow Valid 10 Mbps connection.
Green Valid 100 Mbps connection.
Flashing Traffic is passing through the port.
FDX On Port is operating at full duplex.
HDX Off Port is operating at half duplex.
Module Ports
Link &
Activity
On A module is installed in this slot.
Yellow Communications have been set to 1000
Mbps.
Flashing Traffic is passing through the module.