User's Manual

C OMMAND L INE I NTERFACE
5-2
Minimum Abbreviation
The CLI will accept a minimum number of characters that uniquely
identify a command. For example, the command “show” can be entered as
sh. If an entry is ambiguous, the system will display a help message.
Getting Help on Commands
You can display a brief description of the help system by entering the help
command. The system will list the command groups as shown below.
For a full list of the commands included in a group, enter the help
command followed by a group name as shown below.
You can also display help for a specific command by entering the
command keyword followed by the Enter key as shown below.
INET>help
help parameters:
advance port vlan fdb trkgrp
stp qos igmp console
INET>
INET>help advance
advance command:
config ip X.X.X.X
config subnet X.X.X.X
config gateway X.X.X.X
enable bsf <5,10,15,20,25>
disable bsf
show bsf
show ip
show mac
show version
ping <host_ip> <#times>
reboot
INET>
INET>enable
enable parameters:
igmp stp qdlyb <1-255> vlan {gvrp}
bsf <5,10,15,20,25> security <1-10> fdbage
lacpstate <1-8> lacp <groupid:1~4>
sniffer <1-10> rx <portlist> tx <portlist>
INET>