Network Router User Manual

3
CHAPTER 2 | GETTING TO KNOW THE EZ-STREAM WIRELESS
R
OUTER
2.0 | Hardware Description
The Router can be connected to the Internet or to a remote site using
its RJ-45 WAN port. It can be connected directly to your PC or to a
local area network using any of the Fast Ethernet LAN ports.
Access speed to the Internet depends on your service type. Full-rate
ADSL can provide up to 8 Mbps downstream and 640 Kbps upstream.
G.lite (or splitterless) ADSL provides up to 1.5 Mbps downstream and
512 Kbps upstream. Cable modems can provide up to 36 Mbps
downstream and 2 Mbps upstream. ISDN can provide up to 128 Kbps
when using two bearer channels. PSTN analog connections can now
run up to 56 Kbps. However, you should note that the actual rate
provided by specific service providers may vary dramatically from
these upper limits.
Although access speed to the Internet is determined by the modem
type connected to the Router, data passing between devices
connected to your local area network can run up to 100 Mbps over the
Fast Ethernet ports.
The Router includes an LED display on the front panel for system
power and port indications that simplifies installation and network
troubleshooting. It also provides four RJ-45 LAN ports and one RJ-45
WAN port on the rear panel.
• 4 RJ-45 ports for connection to a 10BASE-T/100BASE-TX
Ethernet Local Area Network (LAN). These ports can
auto-negotiate the operating speed to 10/100 Mbps, the mode
to half/full duplex, and the pin signals to MDI/MDI-X
(i.e., allowing these ports to be connected to any network
device with straight-through cable). These ports can be
connected directly to a PC or to a server equipped with an
Ethernet network interface card, or to a networking device
such as an Ethernet hub or switch.
• One RJ-45 port for connection to a DSL or cable modem (WAN).
This port also auto-negotiates operating speed to
10/100 Mbps, the mode to half/full duplex, and the pin signals
to MDI/MDI-X.